Maumee Auto Repair

We all want to breathe clean air and keep our planet green.  One of the ways to do that is by requiring all vehicles with internal combustion engines to pass an emissions test.  That’s because these vehicles can be big polluters.   Everyone wants their car to pass the test so they can continue their day-to-day driving routine.  But then comes that one day when they tell you your vehicle has failed.  Why does that happen? One of the most common reasons is that your gas cap is leaking or loose (or maybe you don’t even have one on your vehicle!).  The gas cap is supposed to seal in vapors, but sometimes its seals or gaskets dry out or crack. Replace it, and you’re good to go. Another common reason your vehicle failed the test is that your catalytic converter isn’t doing its job. It is supposed to convert toxic gases from your engine into ones that don’t pollute the air.  There are many reasons the catalytic converter may not ... read more

If you own a newer vehicle, your vehicle’s manufacturer may require that it use synthetic oil instead of conventional oil.  Synthetic oils are more stable, don’t break down as easily, and provide better engine protection than conventional oil. All those things can prolong the life of your engine and help it run better. Imagine the damage that could happen to your engine as it operates at high speeds and very hot temperatures.  Oil reduces the friction between the metal parts.  That’s why it’s important that it maintains its lubricating properties for a long time, which synthetic oil does better than conventional oil.   Clean oil is better than dirty oil because it has fewer impurities.  Synthetic oil is purer because of how it’s formulated and manufactured.  Plus, as the outside temperatures change, the ability of oil to operate in those conditions is important.  
For example, the colder it gets, it’s important f
... read more

If your vehicle’s power goes to the rear wheels, then you have something called U-joints in the drivetrain. U-joints are connectors that allow the rotating power from your vehicle’s engine to deliver its power through a driveshaft to make the rear wheels rotate.  You need U-joints because the surfaces you drive on aren’t perfectly flat, and the driveshaft has to allow for some flexibility when you are traveling over uneven surfaces. As you can imagine, the U-joints have to move and flex a lot as your vehicle is going down the road.  They have bearings in them to allow that flexibility, and those bearings are lubricated when your vehicle is made.  Some U-joints have lifetime lubrication and are not designed to be serviced.  When they fail, they have to be replaced.  Others have grease fittings on them that need periodic lubricating by a technician at intervals recommended by your vehicle’s manufacturer.  There are signs you can look ... read more

Ever wonder how your vehicle’s engine is able to take the 12-volts from its battery and ramp that up to as high as the tens of thousands of volts it takes to fire its spark plugs? The secret is something called an ignition coil.  Most newer vehicles have an ignition coil at each cylinder, but older ones have a coil that serves all of the spark plugs.  There are telltale signs that you have an ignition coil problem.  As you might expect, one symptom is it’s hard to start your engine or it won’t start at all.  If your engine is misfiring or not running smoothly or you see the Check Engine light come on, those all could point to an ignition coil failure. Several things can contribute to ignition coil trouble in addition to normal wear and tear. Moisture and dirt may have gotten inside the coil, plus the heat and vibration of your engine over time can contribute to them going bad.  Bad spark plugs or plug wires can also be a cause.   While ig ... read more

As your vehicle ages, its performance isn’t quite what it used to be, but many of us never notice the change because it’s gradual.  So here are a few questions to ask yourself.  Does your vehicle feel like it doesn’t have the pep that it used to? Have you noticed your fuel economy isn’t quite as good as it once was? Does it idle roughly or is it hard to start?  Do you hear the engine knocking? Has it recently failed an emissions test? All of those can be signs that your fuel and air induction systems are dirty and need cleaning.  Your fuel system takes gasoline from the tank to the engine’s combustion chambers where fuel injectors spray fuel that mixes with air and is ignited by spark plugs.  Black carbon deposits eventually can build up, obstructing fuel flow and diminishing your engine’s performance and fuel efficiency. The air induction system is what allows air to go into the engine’s combustion chamber.  Getti ... read more

For most drivers, at some point you’re going to have a flat tire. Depending on how it was damaged, it may have to be replaced.  But sometimes, a repair will do the trick, as long as the puncture isn’t on the sidewall and the hole is smaller than ¼ inch/6.35mm in diameter. Here are the three common ways your tire can be fixed. One way is to put a plug in the hole.  Since most tires are damaged by running over sharp objects such as screws and nails, the small hole from which the air is escaping is on the part of the tire that touches the road. If it’s in the sidewall, it most likely can’t be fixed.   In the plug method, a technician inserets a rubber plug.  It is covered with some sticky, gluey stuff, and is pushed into the hole from the outside. That plugs the hole and stays in place, thanks to the glue. Friction from driving heats it up and seals the deal.   Another method is to patch the hole.  For this, your tire has to fir ... read more

Think of how many times you put your foot on your vehicle’s brake pedal every day.  And think of how much you rely on your brakes to slow down and stop your momentum.  When it comes to safety systems, your brakes are at the top of the list, and that’s why it’s so important to keep them in top condition. Brakes are something you make sure you keep maintained before they start showing signs of problems. Some of those signs are a grinding sound when you step on the brake pedal, your vehicle pulling to one side when you brake, you don’t feel your brakes stopping you as quickly as they used to, or you notice the brake light is illuminated on your instrument panel.  We ask a lot of our brakes.  They have to work no matter how hot or cold it is outside.  That means whether it’s sunny, snowing, raining, or icy; you’re traveling at highway speeds or school-zone speeds; or when suddenly you find yourself trying to avoid hitting another ... read more

If you have a front-wheel-drive vehicle, it has components called CV joints which enable you to turn your wheels smoothly. The CV stands for “constant velocity.” In essence, it’s a set of gears that connect a shaft that allows power from the transmission to be sent to the wheels.  When you turn the wheels, no matter what angle, the input velocity rotation will be equal to the output. Thus, the name, CV (constant velocity) joint. Other vehicles with 4-wheel drive and all-wheel drive also use CV joints.   If one of your CV joints isn’t working right, you may find your vehicle difficult to handle.  If one breaks, your vehicle may stop moving.  So, it’s important that CV joints be in top working condition.  The joints need a lot of lubrication, so they are surrounded by grease.  There’s a rubber enclosure around them called the boot which holds the grease in and protects CV joints from the elements. 
 
The bi

... read more

A clean connection is a wonderful thing.  Think of a good cell phone signal or an airline connection with ample time and short distance to the next gate. Good connections are also important for your vehicle’s battery, and one secret to that is to make sure it’s periodically cleaned. If it’s been a while since you have had any service to your battery, bring it in so we can inspect it for any corrosion that might have formed.  Corrosion on the battery terminals will affect the connection between the battery and your vehicle’s electrical system. The amount of corrosion you can expect can be influenced by such things as the kind of climate you live in (dry or humid, warm or cold), if there’s lots of salt on the roads and how old your battery is.   We have tools and chemicals to safely remove the corrosion for an optimal electrical connection. In order to reduce the amount of corrosion re-forming on the battery, we’ll apply a special protec ... read more

Ever wonder how your vehicle is able to move over bumps, potholes and other irregularities in the road and you hardly feel a vibration in the cabin? It’s your shocks and struts doing the hard work along with the rest of your suspension and tires.  They keep the ride smooth and are important for your vehicle’s safe operation.  So, how do you know when your shocks and struts are wearing out? One way is to look at the surface of your tire (where the rubber meets the road—where the tread is).  You might see some little indentations in certain spots, known as tire cupping.  If your vehicle takes longer to stop than it used to, takes a dive when you hit the brake pedal or bottoms out (scrapes) on a big bump in the road, that’s another sign, as are loud, odd noises. You may also notice your vehicle sways more than it used to. Every once in a while, look around at your shocks to see what shape things are in.  If you see the rubber cover cracked ... read more