Maumee Auto Repair

If you hear a squealing noise when you turn your vehicle, it's trying to tell you something is wrong.  After all, it never made that noise before, right?  The sound  you hear may becoming from a few sources.  Let's take a look (or a listen) to some of the possibilities. First, you almost certainly have power steering in your vehicle. Without power steering, you practically have to have arms like Arnold Schwarzenegger to turn, so automakers have technology to assist your steering, either mechanically or electrically.  For a long time, the most common power steering has been hydraulic, using a belt to supply power from the engine that turns a power steering pump full of a fluid that helps you steer.  Sometimes that fluid gets low because of a leak or some other problem.  The belt could wear out and start squeaking, and you might feel the steering start to become harder.  Your service repair facility can figure out the problem and offer some solutio ... read more

We usually take our vehicle's easy steering for granted until something goes wrong.  Power steering is what makes it almost effortless to turn the steering wheel, aiming your vehicle in the direction you want to go. Without the assistance of power from the engine, steering would be a laborious process, so you want to make sure the system is working well. Power steering systems are usually one of two types, hydraulic and electric.  The hydraulic type uses a pump that is driven by either a belt or an electric motor.  This system uses hydraulic fluid to create pressure that gives your steering the power assist.  Since that pump is always working, time and distance traveled eventually take their toll, and these systems need to be periodically inspected.  Also, while that hydraulic fluid can last for years, it should be replaced periodically as it degrades over time. Your vehicle's owner's manual contains the manufacturer's recommendations. A technician can check fo ... read more

There are some boots that don't come in a shoe box and aren't worn on your feet.  They are called axle or CV boots, and they can be important parts for many vehicles. That CV stands for constant velocity.  CV axles are mainly used in front-wheel drive and all-wheel drive vehicles. They're also used in some rear-wheel drive vehicles with independent suspensions.  They have two CV joints, one inner and one outer, placed between the axle and the drive wheels.  That way the vehicle's engine power can drive the wheels, no matter what angle they are.  They also adjust for the different speeds wheels turn as they go around corners.  Because roads are full of all sorts of hazards (dirt, oil, water, grime), these CV joints need to be protected.  They also have grease in them to keep the bearings moving smoothly.  That's the job of the rubber boots that are supposed to keep that debris out.  These CV or axle boots are made of rubber or plastic and usu ... read more

We've all been there.  You park your vehicle on a steeper than usual hill and worry about it rolling down while you're running your errands.  So you decide you'll use the parking brake.  When you get back, you release the parking brake, hit the ignition, put it in gear and—uh, oh—you can feel the parking brake is still on.  It's stuck.  What do you do now? Welcome to the world of infrequently-used parking brakes.  Yes, they do stick for several reasons. It's common for components to corrode and get locked up.  Sometimes if you have applied it extra hard, it can jam.  Could be a rusty cable, could be a spring that doesn't return the brake to its disengaged position.  Some pieces just break when they're stressed for the first time in a while. A caliper or the pivot arm it's on can also stick. There are a few things you can try to unstick it.  Carefully rock your vehicle by putting it first in drive and then reverse.  You ... read more

We've all heard that expression, "That's a non starter." When it comes to your vehicle, that's not music to a driver's ears. That sickening sound when you start the ignition and instead of hearing the engine crank, you hear it slowly turn over and your dash lights go dim.  There can be many reasons a vehicle won't start, so here's a little history of how the starter came to be an important component of modern vehicles. You have to move the engine's components to start it. The first cars had a crank that the driver would insert into the front, then start turning things over by hand.  When the engine started, you had to release that crank immediately or risk a broken arm.  Yes, it happened many times.  So, they came up with a better idea: an electric starter, which was a big advance in automotive technology. With this system, an electric motor rotated a series of gears that turned the gasoline engine's crankshaft so its pistons and parts moved and the engine drew in a ... read more

Rust.  It's worse if you drive in places that use salt on the roads in winter, or if you spend time driving near a body of salt water.  But any vehicle has to deal with rust after years on the road.  And it's not just that rust can eat away your vehicle's body and fenders.  It can be a real problem around your suspension, drivetrain or any place where there's metal. Rust takes its time.  You don't see it until it's already done its dirty work.  It can wreak havoc with your electrical system.  Sure, vehicle manufacturers do their best to keep it to a minimum, but especially with road treatments like brine around, their task is a difficult one. The one spot everyone notices is in the paint.  You see a little bubbling under the once-smooth surface.  By the time it bubbles, it's well involved in rotting away that spot of your vehicle.  You wouldn't believe how just a little thing can start the process on its way.  A stone chips the pai ... read more

Of the things you think about most, your tires are probably pretty far down the list. That’s understandable because today’s tires are engineered to do their job without needing you to pay too much attention to them. But they DO wear out, and worn tires can contribute to skidding in bad weather, not being able to stop, a ride full of uncomfortable vibrations and, even a sudden blowout. Yikes. Let’s figure out right now how to know if your tires need replacing! Let’s face it. Most of us don’t know the first thing about tires. So, the best way to make sure what shape yours are in is to take your vehicle to a qualified service facility to have the tires checked out by a trained technician.  Here are things they’ll check: Tread.  Tread is the part of the tire that touches the road surface.  Different tires have different tread patterns and something called tread blocks - the raised rubber parts that contact the road. The longer a tire has ... read more

When you head to the doctor, you probably have it in your mind what you're going to say about why you don't feel good.  That way your doctor can use that information to diagnose your problem. You might want to think of that same approach when you take your vehicle in for a repair. Experts say what will help the service advisor most is for you to bring in some well-organized descriptions about your vehicle's issues.  You might even want to write them down so you don't forget.  Is there an unusual smell?  What does it smell like?  Does the problem happen first thing after starting out? If there's an odd sound you hear, is it dependent on speed?  Does it change when you turn a corner?   Keep your expectations realistic.  Some conditions may take a long time to diagnose and repair.  If you go thinking you'll be in and out in no time, you might be disappointed when you're told there are other customers ahead of you and you may have to come b ... read more

Engines required a lot more maintenance in earlier times.  You'd have to have your spark plugs, wires, rotors, caps, distributor points, fuel and air filters changed periodically.  There were mechanical adjustments of a vehicle's timing, dwell, spark gap and idle mixture, too. Unless you like to tinker with old cars, a lot of those terms won't mean much to you.  That service was called a "tune up" back then, and you can see why.  But now, computers have reduced the number of maintenance items, and a tune up is a whole lot different than it used to be.  In fact, in some vehicle service facilities, that term is also a thing of the past.  A tune up of today would more accurately be called simply periodic maintenance. Now, most vehicles still have spark plugs and wires, fuel filters, air filters and PCV valves, and they should be inspected tested and/or replaced at regular intervals.  Your vehicle's manufacturer has made recommendations on how often that ... read more

If you were to name the most important safety feature on your vehicle right now, what would your answer be? A lot of driving experts would agree that it’s your brakes.  Most newer vehicles use a well-engineered and efficient style of brakes called disc brakes.  The name disc brakes comes from one of the components: a disc attached to the wheel hub that is squeezed by parts called calipers.  If you’ve ever ridden a bicycle with hand brakes, you probably have seen how they squeeze against the rim of the bike wheel to stop the bike. It’s similar to the way your vehicle’s calipers squeeze against the disc rotor, with added parts called brake pads attached to the calipers that are what create the friction and stop your vehicle. Here’s why disc brakes need regular maintenance.  Over time, that friction creates wear and tear on the brake pads and the rotors, and you’ll start to see the signs.  Your brakes may have one of the 3 &ldqu ... read more